Abbstud

High Load Performance Resin Anchor Data Sheet is based on an M20x210mm long Abbstud with an embedment depth of 160mm in a hole 24mm diameter. Available from M6 to M30 (dimensions are the diameter of the anchor) Application Crash barrier posts and similar installations. Description The ABBSTUD has been designed for crash barrier and parapet post fixings. It is installed into the concrete so that the stud is protruding from the concrete surface, and the unit to be fixed is lowered over the protruding stud and secured with a nut. The ABBSTUD is made from stainless steel grade 316, and comes complete with a stainless steel hexagon full nut grade A4/80 and a stainless steel washer grade A4. Features Allows minimum edge distances and anchor spacing. Sealed drill holes. Only 24mm hole diameter required. Fixing is corrosion resistant. Fixing cannot be vibrated out. Stress free fixing. Fixing can be made to any length. The ABBSTUD used in conjunction with ABBFIX resin anchor grout will provide a fully bonded seal against the concrete substrate, once it has cured and hardened. Performance Tensile Load in kN 0.2mm SLIP 73.30 1.0mm SLIP 98.30 Failure 106.00 Tests carried out in C20 concrete. Concrete strength at time of test 24.0N/MM.2 These results were provided from tests carried out by a NAMAS ACCREDITED laboratory to BS5080 PART 1 1993, for ABBOT FIXING SYSTEMS LTD.

Technical Services
For further information please contact our sales office.
On-site testing service to BS5080 Part 1 is available.

Application
Crash barriers, Parapet posts and similar installations.

Fixing Procedure
Drilling 24mm x 160mm
Drilling should be carried out by using rotary percussive equipment. If diamond drilling is required where steel reinforcement is present, then the hole must be under-reamed or roughened.

Cleaning of Holes
All holes should be clear of dust and debris, by using a compressed air lance or blow-out bulb in addition to wire brushing.

Mixing of Resin
The ABBSTUD should be used in conjunction with ABBFIX Resin Anchor Grout, mixed according to the instructions on the pack.

Installation
To ensure complete encapsulation, it is recommended that the resin is poured into the hole prior to the installation of the ABBSTUD. Push the ABBSTUD down into the resin with a twisting action.

Important Note
To the best of our knowledge and belief, the information contained in this leaflet is true and accurate, but as conditions of use and any labour involved are beyond our control, it is the responsibility of the customer to satisfy himself that this product is fit for the purpose for which he intends to use it, and no responsibility can be accepted, or warranty given by our company.

For further information telephone on 01908 511730